Torque the handlebar stem clamp bolts, starting with the lower bolt, to 12 Nm. Align the stem and handlebar with the front wheel so the handlebar is pointing forward.Torque between 4-6 Nm, depending on headset play, and reinstall the rubber cap. If the wheel doesn't turn when the bike is leaned over, the headset is too tight. Lean the bike over to the side (onto the kickstand, so the front wheel is off the ground) to make sure it's not too tight. Install the top cap and bolt. Tighten the top cap bolt until there is no play in the headset.Install the handlebar stem onto the fork. Make sure there is a small gap in between the top of the steerer tube and the handlebar stem. ![]() Refer to the photo taken earlier, if needed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |